360° Wrap Print Preview — see the back seam before you order
Upload your full wrap-around artwork. We wrap it around the bottle and show you exactly where the two ends meet at the back, magnified. Catch a bad seam before it goes to print — we always make a physical sample for your approval.
About this preview: this is a geometric approximation of a cylindrical wrap. Real results vary with bottle shape, taper, print method (silkscreen / UV / heat transfer / laser) and material. It is a layout aid, not a color proof. A physical sample is made and approved before production.
Set up your bottle
All dimensions in millimetres. Check the numbers on your spec sheet or ask us — we confirm before sampling.
The straight part of the body, outside diameter.
Vertical space available for artwork on the body.
Body circumference (π × Ø)204.2 mm
Ideal artwork ratio (W : H)1.36 : 1
Your image ratio—
Your artwork ratio differs from the bottle wrap. It will be stretched or repeated to fill — check the preview, or send us the artwork and we will set it up correctly.
Your artwork
Upload the whole 360° design as one flat image. Left edge and right edge are the two ends that meet at the seam.
°
Your artwork — where the front and the seam land
front centreseam (left + right edge)what the front view shows
The blue line is the exact middle of your image — that is what faces the buyer. If the person you want is not on the blue line, drag “Rotate the wrap” until they are.
Your image is tall (portrait). A real 360° wrap is a wide panorama — its width should be about 1.4× its height for this bottle. A portrait photo will look stretched. Send us the photo and we will set the repeat / placement for you, or use Design a cup for a single front image.
3D view — spin the bottledrag left / right to rotate · see every angle
Upload your artwork to see the 3D bottle
Drag the bottle to rotate · pinch / scroll not needed
Front viewhow the design reads from the front
Back viewseam at back centre
🔍 Back seam — magnifiedleft end × right end, where they join
Upload your wrap artwork to preview the cylinder and inspect the back seam.
Only the dashed red line on the back view and the seam close-up are drawn by this tool — they mark the seam, where the two ends of your artwork meet. Any other line you see inside the picture is already in your uploaded image (for example two photos joined together); we cannot remove it, we just show it where it lands on the bottle. A colour or line break at the seam is what you want to catch before printing.
1
Upload one flat imageThe full 360° wrap. Its left and right ends become the seam.
2
Check the back seamRotate the wrap and zoom the seam to see if the two ends line up.
3
Send it to usWe set it up on the real cup and make a physical sample for approval.
360° wrap printingseam alignment checkcylinder previewcustom logo tumblerOEM drinkware